NBC-500P All-digital Pulse MIG Welder

Features:

• Functions are controlled by a DSP chip and can save 30 sets of parameter
• Automatic switch off  in over-current, over/under-voltage, over-heat, phase lacking
• Support fast forward selection on the front panel
• Suport MMA,MIG/MAG and Hi-speed MIG/MAG welding
• Stable pulse welding can be realized with 50A current and Φ1.2mm wire
• Very suitable for mid/thick plate pulse welding with Φ6mm wire
• Can be used with robot to realize automatic welding

1. With such functions as primary current/voltage adjustment, 4T current/voltage adjustment, integral/off

  selection, saving and reading of welding parameter, spot welding set

2. With robot interface and group control interface
3. First in China: Hi-speed DC welding

        Advantages:

A．In bottom welding, the backside of welding seam is also good, the defects can be avoided

        B．Penetration about 20% bigger than the general DC MIG/MAG welding in the big current welding (300A)

        C．Welding speed is 15% higher than the general MIG/MAG welding

        D．In fillet welding, welding meat is flat and smooth, no bulge

• Iron water flows smoothly and is easy to control in covering welding

4. Suitable for sold/flux-cored wire

Comparison of DC MIG/MAG welding and Hi-speed DC MIG/MAG welding

Comparison of Hi-speed DC pulse welding and one-pulse one-drop welding

Parameters